Mason’s High Tech Conference Table Test Build

All the parts were finished this week, so Mason could start assembling his new table this week. He was one of our interns this summer. If you are looking for an entry level Industry Designer, then check out his LinkedIn profile.

<

Mason Assembling the New Conference Table that He Designed
Mason Assembling the New Conference Table that He Designed

 

Bottom Section Assembled, Upper Truss is Next
Bottom Section Assembled, Upper Truss is Next
Closeup of the Joinery
Closeup of the Joinery
Table is Made of Aluminum Plates for a High Tech Look
Table is Made of Aluminum Plates for a High Tech Look

 

Montie Roland

Montie Roland is President of Montie Gear, a manufacturer of outdoor sporting equipment in Sanford, NC. Montie is also employed at Pentair in Sanford, NC as a Mechanical Engineer on the New Product Development team. Montie enjoys finding innovative solutions to customer requirements. He has 15 years of experience engineering products in diverse market spaces including industrial, commercial and military. Montie earned a BS in Mechanical Engineering from North Carolina State University. He is also the President Emeritus of the Carolinas chapter of the Product Design Management Association (www.pdma.org/carolinas) and a founder of the RTP Product Development Guild (www.rtpproductguild.com).

Leave a Reply