Paintball Marker Stand

Hey Y’all,

Over the past few weeks we have been working on a Paintball Marker Stand. This stand can be broken down into three pieces using the pins on the sides of the stand. The marker is supported by the U-Shaped cut out in the back of the stand and the Slot in the front of the stand. The sliding cylinder, seen in the middle of the stand, allows this stand to support the marker and prevent it from falling forward and out of the stand. This slide also allows the stand to work with multiple markers. Everything is going well and we should be trying out a prototype soon.

Thanks for Reading,
Daniel Helms

Paintball Stand Render 1.WITHMARKER

Paintball Stand Render 1.WITHOUTMARKER

Paintball Stand Render 1.FRONT

Paintball Stand Render 1.BACK

Ball dispenser sent off for prototyping

Hey!

So the belt clip ball dispenser is finally coming together. After testing more mock-up models the decision was taken not to use any plate or similar to separate the balls from the magnet, as more than one kept falling off when trying to pull only one off. Instead the magnet will be coated with a durable finish and the balls will be in direct contact with it. This simplified the design significantly, but put increased the demand on the aesthetic form of the back plate, as this now became the mail feature of the whole product. A simple plate can have many different forms:

assembly

One option was to add a top bumber to create a feeling of better encapsulating the balls, as well as giving more depth to the product. Unfortunately, the manufacturing complexity of adding this feature was greater than expected. As this would drive up the cost of the product a lot the decision was taken to put this feature on hold for now.

As for the final design the initial round magnet was kept and the plate form includes some curved lines to follow the magnet while still keeping some edges to go with the rectangular belt clip. After quite a bit of struggle finding a good form, this one actually feels pretty obvious I would say! Let’s just hope the prototype will look just as good!

Have a good weekend!

/Richard Boden

untitled.189untitled.191

Dispeser, round, belt.210 copy